Author Topic: Hint: Selectively only display flows with specific unit type  (Read 5517 times)

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 500
  • e!Sankey - show the flow.
    • Umberto - know the flow.
Hint: Selectively only display flows with specific unit type
« on: September 10, 2007, 03:13 PM »
Sankey diagrams may contain flows with different unit types. The unit types used are selected in the "Edit Unit Type" window, that can be called from the Controller panel. As a default, only "mass" and "energy" are active, but others can be added any time.

If in a diagram with several different unit types, you wish to hide all flows based on this unit type, simply remove the tick mark in the check box for the respective slider. These flows will not be shown in the diagram, until the box is checked again.
Peter Müller-Beilschmidt
e!Sankey Forum Moderator
ifu Hamburg GmbH