Author Topic: V 1.2.0.94 - Known issue: printer margin values  (Read 7392 times)

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 597
  • e!Sankey - show the flow.
    • e!Sankey - show the flow.
V 1.2.0.94 - Known issue: printer margin values
« on: August 10, 2007, 02:13 PM »
An unhandled exception might occur, if the print margins in the Page Setup dialog are set to very small values. The printer margin underrun happens, if a value is entered that is below the margin the printer can handle.

To avoid this error, please check your printer documentation and enter at least the value of the permitted page margin.

Note: Typical minimum print margins are 4 to 5 millimeters (depending on your printer). Some printers allow to set "0" as margin value, i.e. it is possible to print on the whole area of the paper.
« Last Edit: December 05, 2007, 09:09 AM by pbeilschmidt »
Peter
e!Sankey Forum Moderator
ifu Hamburg GmbH

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 597
  • e!Sankey - show the flow.
    • e!Sankey - show the flow.
Re: V 1.2.0.94 - Known issue: printer margin values
« Reply #1 on: March 05, 2008, 01:08 PM »
This issue has been fixed in the new version e!Sankey 1.3. Please update if you encounter the problem described above.
Peter
e!Sankey Forum Moderator
ifu Hamburg GmbH