Author Topic: Schema Validation Failed  (Read 7699 times)

Offline bjadams

  • Newbie
  • *
  • Posts: 4
Schema Validation Failed
« on: December 05, 2007, 01:01 AM »
Hi, I am getting the old "Schema Validation Failed" error message when I try to open one of my more complex flow charts.  Is there a rescue for this?

barb

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 594
  • e!Sankey - show the flow.
    • e!Sankey - show the flow.
Re: Schema Validation Failed
« Reply #1 on: December 05, 2007, 09:06 AM »
Dear Barb,

there might be several reasons for this. You can send your .sankey file to our support@e-sankey.com and we can check it. Your data will of course be handled confidentailly by our support staff.

One known issue that might cause this, could be the legend caption in your e!Sankey diagram. We have found out that turning off the legend caption causes an inconsistency in the file. This will be fixed in the next release e!Sankey 1.3

Sorry for any inconvenience caused by this.

Regards,
pbeilschmidt
Peter
e!Sankey Forum Moderator
ifu Hamburg GmbH

Offline bjadams

  • Newbie
  • *
  • Posts: 4
Re: Schema Validation Failed
« Reply #2 on: December 06, 2007, 10:48 PM »
The Legend was the problem. I have turned it on and decided I didn't need it, turned it off, then I was stuck.  Fortunately, now that I am getting used to this software, I can build a flow chart very quickly.
barb

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 594
  • e!Sankey - show the flow.
    • e!Sankey - show the flow.
Re: Schema Validation Failed
« Reply #3 on: December 07, 2007, 08:29 AM »
This issue will be fixed in the next version e!Sankey 1.3, due at the end of the year. You will receive an update notification, once it has been released. Sorry once again for the inconvenience caused.
Peter
e!Sankey Forum Moderator
ifu Hamburg GmbH