Author Topic: Arrow Disfunction  (Read 2559 times)

Offline ines-energy

  • Newbie
  • *
  • Posts: 1
Arrow Disfunction
« on: February 25, 2015, 02:26 PM »
Hi everyone
I have a problem with the number of points that are in an arrow. As you can see in the attachement, I try to make a simple arrow with an angle of 90°. But e-sankey does not want to do that. Instead of this simple arrow, it adds an additional curve which is not necessary. Neither can i delete the additional point, nor can I adjust the arrow in the correct way....

I tried this like a thousand times, but it will not work.

Please help :)

Offline Jörn Zietz

  • Administrator
  • Hero Member
  • *****
  • Posts: 193
Re: Arrow Disfunction
« Reply #1 on: February 25, 2015, 06:11 PM »
Dear ines-energy,

This happens because you have switched off 'snap to grid' and activated 'orthogonal' for the arrow - you can see that the two gray arrow points at the arrow cut are very close to each other. I recommend to switch off 'orthogonal', remove all arrow point via context menu and move one of the yellow arrow points to get an orthogonal routing.

Best regards,
Jörn Zietz
Jörn Zietz
e!Sankey Team
ifu Hamburg GmbH